Doors and Trim and Siding

The doors were made from 6" - 5/4 notty pine boards. I was able to join them together in a z bend fashion. Eventually the doors will be cut in half so they can open from the top and the bottom. I also used 3" pine trim board around the windows only. I decided if I trimmed the doors and corners, there might be an odd sized strips to side between the corners, windows, and doors.





Here is a picture of the the hardware used for hinging and latching the door...





...and siding. You can see that the siding used is cedar shingles. It was a lot of work but the outcome was worth the time.



This last picture shows the ridge cap that I finally put on the roof. I used a piece of the corrugated roofing and ripped it and was able to bend it over the ridge. I anchored it down with roofing screws.